# Dip of wall Rock Cutting

**URL:** https://forum.itascainternational.com/t/dip-of-wall-rock-cutting/1074
**Category:** PFC
**Created:** [July 11, 2023, 7:31am UTC](https://forum.itascainternational.com/t/dip-of-wall-rock-cutting/1074 "2023-07-11T07:31:07Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![Sauki](https://avatars.discourse-cdn.com/v4/letter/s/c5a1d2/32.png) [@Sauki](https://forum.itascainternational.com/u/Sauki)
#### Post date: [July 11, 2023, 7:31am UTC](https://forum.itascainternational.com/t/dip-of-wall-rock-cutting/1074/1 "2023-07-11T07:31:07Z")

</div>

Hello everyone,

I am trying to generate a wall for rock cutting process. Is anyone know how to change the dip of wall to different degrees? I have seen the commands of wall generate command on [wall generate command — PFC 7.0 documentation (itascacg.com)](https://docs.itascacg.com/pfc700/pfc/pfcmodule/doc/manual/wall_manual/wall_commands/cmd_wall_generate.html?node2406). But the command for **wall box** can not use the **dip** command, the software says that was an extra parameter for **wall box** command.

 ![Wall dip 2.jpg](https://canada1.discourse-cdn.com/flex031/uploads/itasca/original/1X/40dd330512311f96908c8d72d1537020a3e31d9f.jpeg)

Best regards, Sauki

---

<div class="post-metadata">

### Author: ![dblanksma](https://avatars.discourse-cdn.com/v4/letter/d/858c86/32.png) [@dblanksma](https://forum.itascainternational.com/u/dblanksma)
#### Post date: [July 11, 2023, 3:09pm UTC](https://forum.itascainternational.com/t/dip-of-wall-rock-cutting/1074/2 "2023-07-11T15:09:14Z")

</div>

Hello Sauki,

You can use the `wall rotate` command to rotate walls - [wall rotate command — PFC 7.0 documentation](https://docs.itascacg.com/pfc700/pfc/pfcmodule/doc/manual/wall_manual/wall_commands/cmd_wall_rotate.html?node2415)