# Shear strain/s for calculating shear modulus

**URL:** <https://forum.itascainternational.com/t/shear-strain-s-for-calculating-shear-modulus/1108>\
**Category:** 3DEC\
**Created:** [August 2, 2023, 10:32pm UTC](https://forum.itascainternational.com/t/shear-strain-s-for-calculating-shear-modulus/1108 "2023-08-02T22:32:47Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![VijayKiranKota](https://avatars.discourse-cdn.com/v4/letter/v/c4cdca/32.png) [@VijayKiranKota](https://forum.itascainternational.com/u/VijayKiranKota)\
**Post date:** [August 2, 2023, 10:32pm UTC](https://forum.itascainternational.com/t/shear-strain-s-for-calculating-shear-modulus/1108/1 "2023-08-02T22:32:47Z")

</div>

Greetings!

I would like to calculate the change in shear modulus (shear modulus reduction) of a block element concerning the applied cyclic load. To achieve this, I plan to compute shear stress and strains for specific zones in the block.

After careful consideration, I am leaning towards using the SSmax command, which calculates the maximum shear stress based on principal stresses, for this analysis. However, I have some doubts when it comes to calculating shear strains.

Given that there are over 30 commands available for shear stresses and strains in 3DEC, I am uncertain which one would be the most suitable for my specific purpose. If you could kindly recommend a suitable command for calculating shear strains, I would greatly appreciate your guidance.

Thank you for your attention, and I look forward to your valuable assistance.

Best regards,  
Vijay Kota
