# Two plastic moment definitions for a single element

**URL:** <https://forum.itascainternational.com/t/two-plastic-moment-definitions-for-a-single-element/1288>\
**Category:** FLAC3D\
**Created:** [January 4, 2024, 10:52am UTC](https://forum.itascainternational.com/t/two-plastic-moment-definitions-for-a-single-element/1288 "2024-01-04T10:52:00Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![cgulenc](https://avatars.discourse-cdn.com/v4/letter/c/71c47a/32.png) [@cgulenc](https://forum.itascainternational.com/u/cgulenc)\
**Post date:** [January 4, 2024, 10:52am UTC](https://forum.itascainternational.com/t/two-plastic-moment-definitions-for-a-single-element/1288/1 "2024-01-04T10:52:00Z")

</div>

Hi,

When we assign a plastic moment value to an element, FLAC3D assumes that both ends of the element have the same plastic moment capacity. Is there any way to define different plastic moment capacities at both ends for a single element by employing simple beam hinges? Can we do it by using FISH?

Regards,  
CGulenc

---

<div class="post-metadata">

**Author:** ![cheng](https://avatars.discourse-cdn.com/v4/letter/c/ecccb3/32.png) [@cheng](https://forum.itascainternational.com/u/cheng)\
**Post date:** [January 5, 2024, 7:29pm UTC](https://forum.itascainternational.com/t/two-plastic-moment-definitions-for-a-single-element/1288/2 "2024-01-05T19:29:23Z")

</div>

At present, unfortunately, FLAC3D assumes that they both are the same.

---

<div class="post-metadata">

**Author:** ![cgulenc](https://avatars.discourse-cdn.com/v4/letter/c/71c47a/32.png) [@cgulenc](https://forum.itascainternational.com/u/cgulenc)\
**Post date:** [January 5, 2024, 8:02pm UTC](https://forum.itascainternational.com/t/two-plastic-moment-definitions-for-a-single-element/1288/3 "2024-01-05T20:02:00Z")

</div>

OK. Thank you.

Kind Regards,  
CGulenc
