# Zone face apply servo ramp / reduce
**URL:** https://forum.itascainternational.com/t/zone-face-apply-servo-ramp-reduce/821
**Category:** FLAC3D
**Created:** [November 10, 2022, 10:18am UTC](https://forum.itascainternational.com/t/zone-face-apply-servo-ramp-reduce/821 "2022-11-10T10:18:46Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@Francesco\_IT](https://forum.itascainternational.com/u/Francesco_IT)
#### Post date: [November 10, 2022, 10:18am UTC](https://forum.itascainternational.com/t/zone-face-apply-servo-ramp-reduce/821/1 "2022-11-10T10:18:46Z")
Hi,
I was wondering if, in FLAC3D, there is a way to track the ramp / reduce values during cycling for zone face apply servo command. This to check if, at convergence, the full load has been applied. In FLAC, ramp was a FISH function so it was straightforward to track it but in FLAC3D I didn’t find in a reference in the docs
Thank you in advance.
---
### Author:  [@Moo](https://forum.itascainternational.com/u/Moo)
#### Post date: [November 11, 2022, 2:12pm UTC](https://forum.itascainternational.com/t/zone-face-apply-servo-ramp-reduce/821/2 "2022-11-11T14:12:46Z")
There isn’t a FISH connection, but if you LIST the condition using ZONE FACE LIST APPLY you can see the current multiplier value.
---
### Author:  [@Francesco\_IT](https://forum.itascainternational.com/u/Francesco_IT)
#### Post date: [November 14, 2022, 9:52am UTC](https://forum.itascainternational.com/t/zone-face-apply-servo-ramp-reduce/821/3 "2022-11-14T09:52:08Z")
Thank you @Moo for your suggestion, it could be good to have such connection in the next releases.