Dip of wall Rock Cutting

PFC
1

Hello everyone,

I am trying to generate a wall for rock cutting process. Is anyone know how to change the dip of wall to different degrees? I have seen the commands of wall generate command on wall generate command — PFC 7.0 documentation (itascacg.com). But the command for wall box can not use the dip command, the software says that was an extra parameter for wall box command.

Wall dip 2.jpg
Wall dip 2.jpg1876×1083 132 KB

Best regards, Sauki

2

Hello Sauki,

You can use the wall rotate command to rotate walls - wall rotate command — PFC 7.0 documentation